Grain Orientation and Timber Performance

Although this varies through different species, the deformation is always greater in the direction tangential to the rings than in the radial direction.

Grain orientation has a massive impact of the stability and performance of wood in exterior applications.

Heartwood performs differently during the drying process, and also has an impact of performance of exterior timber.

Certain timber cuts can be targeted to improve the drying and the overall exterior performance of exterior timbers. Some of the common sawmilling cuts can be found below:

Flat Sawn

Flat sawn is the most widely used method to produce timber, and is the most efficient way to break down a log, however the output is not the best quality in terms of stability, and most contain a core of heatwood. Flatsawn timber is most likely to warp and cup in application.

Rift Sawn

Rift sawn is a cut that creates a perfectly vertical grain. Rift is not commonly used, and can create a lot of wastage during production.

Quarter Sawn

Quarter sawing involves breaking the log down in a manner where the grain is mostly vertical, this method is more efficient than rift sawing, and still provides a great result. Abodo’s Sand Decking features a vertical grain, achieved from quarter sawing.

A vertical grain orientation has three main benefits:

1. Stability

As wood tends to shrink and expand more tangentally compared to radially, the shrinkage and expansion is halved with vertical grain.

This means that coatings will last longer on timbers with vertical grain orientation.

2. Surface Cracking

In exterior applications, wood typically cracks perpendicular to the grain. This means that flat sawn timbers will have more visible cracking than quarter sawn, vertical grain boards. Surface cracks can harbour moisture, leading to premature decay - this means that vertical grain products last longer, and hold coatings better than those that are flat sawn.

3. Long Term Performance

Grain orientation has a significant effect on long term weathering. Flat grained timbers are more likely to show more surface cracking over time, while vertical grain pieces are less likely to crack. Coatings will last longer on timbers with vertical grain orientation.

This can be clearly seen in these two contrasting timber boards – which are made from typical CCA H.32 treated pine

The top piece is flat sawn, and exhibits severe surface checking. The bottom piece was cut with a vertical grain.